Inhalater Vaporizer

The Inhalater is an electronic phytotherapeutic vaporizer in which plant medicine can be extracted.

The patented vaporization chamber of the Inhalater, permits quick and uniform heating of the substrate placed into it. These vapors can then be inhaled for their medicinal properties.

Included in the Inhalater INH004 Kit:

1 x Inhalater INH004 Electronic Phytotherapeutic Vaporizer
1 x AC/USB Power Adapter
1 x USB Power Cable
2 x Vaporization Capsules
1 x Hygienic Tips Pack of 4
1 x Straw Ends Pack of 20
1 x Storage Box
1 x Inhalater Sticker
1 x User Manual

Specs:

Electronically Controlled
Full Temperature Range Selectable
Rechargeable Li-Ion Power Source
Mass = 125g
Length = 6.5 inches
Diameter = 0.875 inch
Heat Up Time = 60 seconds
Full Charge Time for a completely depleated battery = 6 hours
Autonomy = 12 X 8 min cycles
Charge Rate = 500 mA

FAST Free Expedited Shipping in Canada and USA The Inhalater Includes FAST Free Expedited Shipping with Tracking in Canada and USA

Look For The Authorized Logo!
Always look for the Authorized Logo to ensure you are buying a Genuine Inhalater. The advantage of buying from an authorized distributor is you will always get a complete kit with the newest version of the Inhalater Vaporizer. You will also be fully covered by the manufactures 12 Month Limited Warranty and you will receive the best service possible.

Warning

Your Inhalater is exclusively conceived to be used as a phytotherapeutic device.
Use uniquely with completely dried and finely shredded plant material.

Water vapors from a humid substrate can cause severe burns.
Always start vaporization at low temperature when trying untested substrates.

Operation

Shred substrate as finely as possible.
Remove cap from Inhalater and capsule from vaporization chamber.
Insert substrate in capsule using your index finger.
Replace capsule in vaporization chamber.
Activate temperature control and select preferred temperature.
Operation light will flash until desired temperature is reached.

Temperature Selection

For smooth and discrete vaporization, select a low temperature. 1 is lowest temperature, 10 is highest.
For stronger and more visible vaporization, gradually raise the temperature
You may taste substrate or change temperature anytime.

Notice

Vaporization is complete when substrate is uniformly heated brown.
Once finished, wait for apparatus to cool down and empty capsule.
Replace capsule in vaporization chamber and replace apparatus cap.
Your Inhalater INH004 is programmed to auto shut-off after 6 minutes.
You may turn it off anytime by turning temperature control to the Off position.

Battery Autonomy

Battery autonomy should be over 6 cycles when fully charged.
Discharged batteries will prolong heating time.
When completely discharged, Inhalater will auto shut off.

Battery Charging

To recharge the Inhalater battery, plug power cord into Inhalater and AC/USB power adapter.
Green charging light indicator will come on until battery is completely charged.
When completely discharged, full recharging time is 6 hours.
When completely discharged and plugged in with the power cord,
up to 30 minutes of recharging time may be required to have necessary power for using while recharging.
Charging ratio is 6:1. 6 minutes of charging are necessary for 1 minute of operation.

Cleaning

Clean exterior of apparatus with soft rag and mild soap

Clean interior of heating chamber with ISO alcohol and a cotton tip

Clean capsule by soaking it in ISO alcohol and cleaning with a cotton tip

Particle Filter

Eventually the inner filter will clog up with resin and plant material
Replace capsule when necessary.

Pharmacor Technologies grants a 12 month warranty for all of their products. The warranty period shall begin as of the invoice date. During the warranty period Pharmacor Technologies agrees to eliminate manufacturing and material errors free of charge. The warranty shall not cover damages and defects resulting from improper use or maintenance of the equipment. The warranty shall expire if unauthorized parties interfere with the device. The customer does not have the right to amend the contract, reduce the price or repudiate the contract. Pharmacor Technologies shall not compensate any indirect or direct damage. Parts subject to wear and tear shall be exempt from the warranty. The warranty shall be granted only if the complete device, which is not in a disassembled state, is packed well and sent to us with the invoice.

Please send INHALATER's to the following address in cases where your unit needs repair or replacement:

Pharmacor Technologies
6452 Place de la Malicorne
Suite 2
Montreal PQ
H1M 2S7
Canada

We generally suggest sending just the Inhalater, well cleaned and without capsule to conserve privacy relating to phyto-substrate use of your choice.

No posts found

Inhalater

Inhalater Vaporizer

New post

Customers also bought

Categories

Quick Links

Site news

My account

Bestsellers